These two GG&G optical mounting rails were designed to mount easily over the integral rails of the AR-15/M16 flat top receiver and work in conjunction with any of our back up iron sights. The rails mounting brackets raise the line of sight by 1/2 inch, to offer a proper cheek weld when optical devices are attached. In addition, they serve to protect the flat top receiver's integral rails from the damaging wear associated with lever type quick-release mounts, especially those without buffer pads. The GG&G Scout Rail extends two inches beyond the upper receiver and cantilevers over the handguards including the M4 forearm. It was developed to accommodate long-eye-relief "scout"-type scopes and Aimpoint red dot sights with night vision monocular mounted to their rear. The Standard Rail is employed mainly as a riser for conventional optical sights. When mounted with a GG&G back up iron sight, it is flush with the end of the receiver.
Both the Standard and Scout length mounting rails are manufactured in the USA at our Tucson, Arizona factory. Because these AR-15 and M-4 rail mounting systems are used in combat situations, they are designed and tested extensively before they are sold.
![]()
These two GG&G optical mounting rails were designed to mount easily over the integral rails of the AR-15/M16 flat top receiver and work in conjunction with any of our back up iron sights. The rails mounting brackets raise the line of sight by 1/2 inch, to offer a proper cheek weld when optical devices are attached. In addition, they serve to protect the flat top receiver's integral rails from the damaging wear associated with lever type quick-release mounts, especially those without buffer pads. The GG&G Scout Rail extends two inches beyond the upper receiver and cantilevers over the handguards including the M4 forearm. It was developed to accommodate long-eye-relief "scout"-type scopes and Aimpoint red dot sights with night vision monocular mounted to their rear. The Standard Rail is employed mainly as a riser for conventional optical sights. When mounted with a GG&G back up iron sight, it is flush with the end of the receiver.
Both the Standard and Scout length mounting rails are manufactured in the USA at our Tucson, Arizona factory. Because these AR-15 and M-4 rail mounting systems are used in combat situations, they are designed and tested extensively before they are sold.
![]()
You must be over age 21 to view this content