Multi-Flex Quick Detach

Mounting System

For Aimpoint 3X Magnifier And

ITT PVS-14 Monocular

Aimpoint CQB Set Up

GG&G QD Multi-Flex Base

Behind Aimpoint CompM2

Aimpoint Long Range Set Up

Aimpoint 3X with GG&G QD

Multi-Flex Mounting System Behind Aimpoint CompM2

GG&G is known for making Aimpoint Bases that improve accuracy and functionality. In 2006, Aimpoint introduced a 3X magnifier that can be used in conjunction with all Aimpoint scopes for long-range aiming. When coupled with the GG&G Quick Detach 3X Adapter and QD Multi-Flex Mount it can be removed in seconds for CQB situations or installation of the ITT PVS-14 Night Vision Monocular for night targeting. The GG&G Quick Detach Multi-Flex System also allows the Aimpoint 3X to be used effectively behind the EOTECH Holosight as shown in the photographs below. When not weapons mounted this new 3X magnifier can also be used as a hand-held observation device. The magnifier does not have a reticle of its own but uses the red dot or reticle in the Aimpoint or EOTECH as the aiming reticle. This eliminates the need to re-zero when shifting from non-magnified to magnified use or vice versa.

Aimpoint CompM2

Night Targeting Set Up

ITT PVS-14 NV Monocular In GG&G QD Multi-Flex Mounting System Behind Aimpoint CompM2

The GG&G Quick Detach Multi-Flex High Mount is basically our QD Night Vision High Mount slightly re-designed to accept both the mounting ring for the ITT PVS-14 night vision monocular and the GG&G Aimpoint 3X Scope Mount Adapter. It is fully compatible with MIL-STD-1913 dovetails. As can be seen in the photos, the Multi-Flex High Mount and Aimpoint 3X Magnifier Mount set up is best used behind the Aimpoint Comp M2 when it is mounted in a component such as the GG&G Aimpoint Cantilever Ring or an Aimpoint QRP mounting ring. The GG&G QD Multi-Flex High Mount is manufactured from 6061 T6 billet aluminum and type III hard anodized matte black to mil-spec. The steel components of the Multi-Flex Mount are manufactured from 4140 ordnance steel manganese phosphated matte black per mil-spec. The mounting ring for the ITT PVS-14 is manufactured from 4140 ordnance steel and manganese phosphated matte black per mil-spec.

EOTech 552

Long Range Set Up

Aimpoint 3X with GG&G QD Multi-Flex Mounting System Behind

EOTech 552

Night Targeting Set Up

ITT PVS-14 NV Monocular In GG&G QD Multi-Flex Mounting System Behind EOTech 552

The GG&G Aimpoint 3X Adapter should fit the mounting base of all of the GG&G PVS14 High Mounts purchased after April 15, 2005. GG&G PVS-14 High Mounts having the two rear set screw configuration purchased prior to that date, can be retrofitted and adjusted to accept the Aimpoint 3X Mount for the nominal amount of $25.00 plus shipping. This tuning procedure will insure a proper alignment and fit for multiple uses.